From 1 February 2011, Jetstar started its co-operation with the oneworld alliance, allowing people booking an itinerary with a full oneworld member to include a Jetstar flight in the itinerary. However, the flight must be sold via Jetstar's corporate parent Qantas, under a QF flight number.
Mr. Brian Danowsky (M.S. in Aerospace Engineering, Iowa State University, 2004; B.S. in Aerospace Engineering, Iowa State University, 2002). Mr. Danowsky is a Principal Research Engineer at Systems Technology, Incorporated, where he has been since 2007. His main areas of expertise are dynamic modeling and simulation of air vehicles, flight control and guidance systems, robust stability and control, aeroelasticity, aeroservoelasticity and aerodynamic parameter estimation. Flight vehicles of study at STI have consisted of high altitude lighter-than-air vehicles as well as high speed fighter aircraft. Mr. Danowsky is currently and has been the principal investigator for numerous government programs in the areas of aeroelasticity and aeroservoelasticity for NASA, the US Air Force, the US Navy, and the US Army. Research objectives for these programs consist of incorporating active feedback control into very high fidelity coupled computational fluid dynamic and computational structural dynamic models, reduced order modeling capability, aeroelastic uncertainty analysis, adaptive aeroservoelastic suppression, nonlinear aeroservoelastic free-play analysis, and buffet load measurement. Mr. Danowsky received the Dave Ward Memorial Lecture Award from the Aerospace Control and Guidance Systems Committee in 2013 for technical contributions to aeroservoelastic control. He is an Associate Fellow of the American Institute of Aeronautics and Astronautics (AIAA) and is an active member of the AIAA Atmospheric Flight Mechanics Technical Committee. He is also a member of the Tau Beta Pi and Sigma Gamma Tau national honor societies.
Single-spindle automatic lathes feature a parallel numerical control (PNC) system and TB-Deco software. The PNC technology replaces mechanical cams by creating electronic paths to the individual tool holders, all controlled by a clock. The TB-Deco software, run on Windows, controls all aspects of machining and can be programmed on any PC. Three different models (20, 10, and 7 mm) of the Deco 2000 series are offered in four different axial configurations. Specifications for the 20-mm version include maximum workpiece lengths of 200 mm, headstock spindle speeds up to 10,000 rpm, and a 5.5-hp motor. Tornos Technologies U.S. Corp., 70 Pocono Rd., Brookfield, CT 06804.
Access to comprehensive electronic databases containing medical device regulations, standards, and guidelines is available by subscription. Offered in CD-ROM and Internet versions, the libraries are useful to R&D engineers designing medical devices and to regulatory affairs professionals needing to keep up with both U.S. regulations and European directives related to CE marking. The libraries also reveal industry trends and decribe the requirements for entering Japanese medical device and pharmaceutical markets. Subscribers receive free industry news feeds, daily Federal Register updates, and unlimited toll-free technical support. IHS Health Information, Booth 1301
Training the unit operators to use the degreasing system efficiently was important, Consiglio says. "In order to minimize fluid loss, operators need to raise the parts baskets slowly after the cleaning cycle so that the fluid evaporates and recondenses fully on cooling coils rather than being brought out of the freeboard area," he says. A sliding cover over the two sumps is moved into place whenever the system is not in operation to prevent air turbulence from drawing out the denser cleaning vapor. 2b1af7f3a8